Roller Extractor BHO

CHARACTERISTICS​

- BHO M150: model 15 cm long and 30 mm in diameter, with a capacity for about 10 grams of shredded buds

- BHO L200: 20 cm long and 30 mm in diameter, with a capacity for about 15 grams of shredded buds

- BHO XL300: 30 cm long and 30 mm in diameter, with a capacity for about 20 grams of shredded buds

Optionally, the extra coupling can be used to extend the Roller Extractor, suitable for any combination between the different models.

BHO Roller Extractor is composed of:​

- Stainless steel threaded pipe

- Polyethylene union with aluminium thread, gas inlet, adapted to the typical gas chargers of the market.

- Stainless steel union with aluminium thread of one hole, with mesh for filters for a better impulsion and dragging (60 microns).

- 6 Custom die-cut replacement filters

- Special gift of 3 roller alda cigarette paper tubes with natural rubber (L44:50 sheets of 76 x 44 mm; R36: coil 400 x 36 mm; R44: coil 400 x 44 mm) and 50 pre-folded carton filters

GUIDELINES

What should we have prepared?

- Tray or container of pyrex (that endures from -40º to +100º) with a minimum of 500 cc capacity

- Gloves (to protect against gas cold)

- Hot water (65 - 70º)

- Vegetable matter (the amount varies depending on the model to be used

- Blades to collect the extraction

- Gas canister (refined, impurity-free refined gas is recommended, inexpensive commercial brands should be avoided because of its toxicity)

HOW TO USE

- Load the BHO Roller with vegetable matter, press to avoid air pockets. The plant material must be shredded, not need to be powdered.

- Heat the water to about 65ºC and put the water on the Pyrex

- Put the BHO Roller on the Pyrex and introduce the gas through the mouthpiece until the extract of the vegetable matter is removed (the extraction must be carried out in a very ventilated place or outside).

- We wait until the gas evaporates and recover the oil or resin with a knife

Roller BHO is manufactured for "educational use" not for illegal purposes, but as a Gas Resin Extractor.

Handling and use of the Roller Extractor should be carried out in a ventilated place, preferably outdoors. DO NOT SMOKE while handling gas. Avoid close proximity to sources of heat or induction as well as to hot objects.

Gas is a flammable and hazardous material, its handling should only be carried out by adults of legal age.

WHAT PRECAUTIONS SHOULD BE TAKEN DURING AN EXTRACTION?

- Do not smoke

- Do not do the extraction inside a poorly ventilated room (it is recommended to do it outside)

- Do not switch on a switch in the room during extraction

- Do not perform the extraction near a heat source, flame or incandescent body

- Do not inhale the extraction gas (masks recommended)

- Do not wear inappropriate clothing that is too loose (avoid synthetic materials, due to its rapid combustion)

- Wear protective goggles

- Do not open the extractor until some time has elapsed and make sure that there is no gas left inside it

- Do not leave oil extraction unattended